ICON A5 MM : Electrical System : Bilge Pump : Inspection Instructions : Bilge Pump Removal
Bilge Pump Removal
100068-00
The following procedure should be used to remove the bilge pump.
Applicable Aircraft Serial Numbers
00021+
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
03—Electrical System
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove the fuel tank if unable to perform the below steps with tank installed. (Remove Fuel Tank Assembly)
2. Reaching down behind the fuel tank, disconnect the bilge pump hose from the pump by loosening the hose clamp and pulling the hose off the pump’s barb.
3. Detach the pump body from the bottom strainer by depressing the lock bottom and turning counter clockwise.
4. Remove the pump body, leaving the bottom strainer bonded to the bottom of the hull.
Verification Method
The procedure is complete when the bilge pump has been removed.