ICON A5 MM : Instruments (and Avionics) : Garmin G3X Touch™ : Maintenance Instructions : Disconnect Static Line
Disconnect Static Line
100128-00
Use the following to disconnect the Static Line from the aircraft.
Applicable Aircraft Serial Numbers
00139+
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
10—Instruments (and Avionics)
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Identify the static line and cut cable tie securing it to the wire harness.
2. Cut cable tie to disconnect tee connector that is securing wire harness and PITOT lines.
3. Disconnect tube from top port of the tee connector.
4. Remove tee connector.
5. Cut cable ties securing STATIC tube from wire harness and PITOT tube.
6. Remove tubing from port on tee connector. (Figure 263)
7. Cut cable to disconnect STATIC tubing from D9144P and D9145P wires. (Figure 262)
8. Remove tube from top port of tee connector.
9. Cut cable tie securing STATIC tube, PITOT tube, and wire harness.
10. Disconnect tube from tee connector.
11. Remove tubing from tee connector.
12. Remove push on tee.
13. Disconnect center tube from top port of tee connector.
14. Disconnect tube from PITOT tee connector and main wire harness.
15. Cut cable tie to disconnect STATIC tubing from PITOT tubing. (Figure 259)
Verification Method
Task is complete when static line is disconnected.