ICON A5 MM : Wing : Flaps : Maintenance Instructions : Flap Surface Removal
Flap Surface Removal
100177-00
Use the following procedure to remove the flap surface from the wing.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
14—Wing
Safety Equipment
As Needed
Consumables
None
Note: 
There are two styles of flap hinge pin. One style retains the pin with snap rings and the other style uses cotter pins. Remove the flap pins by removing snap rings (XSC-113) or cotter pins (MS24665-151) as needed.
Note: 
Avoid operating the flap system with flaps removed. The free end of the actuation pushrods could snag and cause damage.
Task Instructions
1. Extend the flaps to 30°.
2. Support the flap with a cradle from below or with a helper.
3. Remove the AN4C13A bolt, MS21043-4 nut, and two NAS1149C0432R washers that attach the flap pushrod to the flap surface of the affected flap.
4. Remove the hinge pins and 95630A460PTFE washers from all three hinges of the affected flap.
5. Remove the flap from the wing.
Verification Method
The procedure is complete when the flap has been removed from the wing.