ICON A5 MM : Structural Repair : General Bonded Fastener Replacement : General Bonded Fastener Installation
General Bonded Fastener Installation
100206-00
Install disbonded or damaged bonded fasteners and any remaining adhesive using the procedure below.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Specific Tools Required
None
Parts Required
Many bonded fasteners are used in the A5. These include:
CB3000 Large Metallic Base Stud
CB3021 Reverse-Mounted Stud
CB3033 Reverse-Mounted Standoff
CB4000 Large Composite Base Stud
CB4020 Composite Right-Angle Cable Tie Mount
CB5000 Small Metallic Base Stud
CB5001 Small Base Locking Thread Standoff
CB6007 Clip-Retained Corner Nutplate
CB6009 Clip-Retained 2-Lug Nutplate
CB6010 Sealed Two Lug Nutplate
CB9120 Low Profile Cable Tie Mount
CB9205 Strap Fastener
Aircraft System and Number
NA
Safety Equipment
As Needed
Consumables
None
The new fastener must be selected and located in accordance with the appropriate supporting documentation. Contact ICON Owner Support if lacking definition of what fastener to use or where to place it.
Task Instructions
1. Prepare and clean the substrate in the area to be bonded in accordance with the Click Bond® CBPS-206 Rev. E procedure.
2. Loosely install the replacement fastener in the location specified by the appropriate supporting documentation and verify fit.
3. Apply CB200 adhesive to the fastener and install in accordance with Click Bond® procedure CBPS-206 Rev. E.
Verification Method
Once the CB200 cures, remove fixturing and inspect the fastener for security and complete adhesive squeeze out.