ICON A5 MM : Instruments (and Avionics) : ELT : Inspection Instructions : ELT Access
ELT Access
100293-00
The following contains instructions for accessing the ELT for inspection and maintenance.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
10—Instruments (and Avionics)
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Pry the panel clip off the ELT access panel using a flathead screwdriver.
The access panel is located at the bottom of the forward side of the center console near the kneed pads.
2. Swing the top edge of the access panel forward, then remove it by pulling it up, disengaging the retention tabs on its lower edge.
3. The ELT can now be accessed for service. The figure below shows the view looking aft into the ELT bay. Note the orientation of the toggle switch positions.
Verification Method
After the panel is removed, complete the necessary tasks including the ELT Function Test.