ICON A5 MM : Wing : Wing General Maintenance : General Wing Inspection
General Wing Inspection
100317-00
The following should be used to inspect the left and right wings of the A5.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
14—Wing
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Inspect position light attached, lens condition and seal integrity.
2. Fold wings and verify the function of the wing fold sockets and release buttons.
3. Inspect fuel vent for obstruction and condition.
4. Visually inspect all metallic fittings in wing fold interface for corrosion and damage.
5. Visually inspect all metallic hinges for corrosion and damage.
6. Visually inspect placards for damage, peeling, fading and legibility.
7. Check bond integrity of vortex generators on wing skin. Ensure all 17 pair per wing are installed.
8. Count the wing vortex generators to confirm all are present. There should be 34 pair (17 pair per side).
9. Check bond integrity of stall strips on leading edge of wing skin. Ensure 1 is installed per wing.
10. Check bond integrity of flap root fences and paint condition in the vicinity of lower surface of center wing skin.
Verification Method
Completing the steps above with everything checking as acceptable accomplishes the general wing inspection.