Install G3X Center Stack Bezel
100750-00
Use the following procedure to install the G3X center stack bezel.
Applicable Aircraft Serial Numbers
00123+ (Applicable to G3X Configuration Only)
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
ICA014800 (BEZEL PAD PRINTED ASSY, CENTER STACK, G3X)
Aircraft System and Number
05—Equipment and Furnishings
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Connect electrical connector D9011J.
2. If AP controller is installed, connect TB9010.
3. Install 6x Torx 6-32 screws on center stack bottom of center stack, sides of center stack, and top of center stack that connect the center stack to the G3X housing. Torque to 13 in-lbs.
Verification Method
Confirm center stack and all components are secure.
Turn on master switch. Confirm all switches are operating properly and activating their associated function.
Perform a transponder correspondence test. If the control unit was replaced, configure the transponder. See 190-01499-10 Garmin GTX 34R/45R Installation Manual and 190-01115-01 Garmin G3X/G3X Touch Installation Manual.
Ensure VHF radio header screen turns on and is operable. Test radio transmission and receiving with an external radio.
Parent topic