ICON A5 MM : Landing Gear : Nose Landing Gear : Maintenance Instructions : Replace Nose Landing Gear Actuator : Remove Nose Landing Gear Actuator
Remove Nose Landing Gear Actuator
100425-00
Use the following task to remove the Nose Landing Gear (NLG) Actuator.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
A&P
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
11—Landing Gear
Safety Equipment
As Needed
Consumables
Tef-Gel®
Task Instructions
2. Jack the aircraft up or weight the tail so that the nose gear is clear of the ground (use a safety block under the forward hull if weighting the tail) (796 Empty Weight and CG Measurement While on Jackpoint Scales)
3. Disconnect the NLG actuator electrically from the D9024P connector of the FWD Fuselage Wire Harness.
4. Disconnect the forward attachment bolt of the actuator and retain hardware.
5. Loosen the LARGE CLAMP that connects the NLG Actuator BOOT to the nose landing gear box. Slide the BOOT off the NLG box. Retain all hardware.
6. Loosen the SMALL CLAMP that connects the NLG Actuator BOOT the forward side of the NLG actuator. Retain all hardware.
7. Disconnect the aft connection point of the actuator from bracket attached to the nose landing gear box. Retain all hardware.
8. Disconnect the actuator connector from the FWD Fuselage Wire Harness.
9. Remove the actuator from the aircraft by sliding it out from the nose landing gear box.
Verification Method
The procedure is complete when the actuator has been removed.