ICON A5 MM : Landing Gear : Nose Landing Gear : Maintenance Instructions : Nose Landing Gear (NLG) Wheel Removal
Nose Landing Gear (NLG) Wheel Removal
100435-00
Use the following procedure to remove the nose landing gear wheel.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
ICA009749 (WING HARD JACKING POINT)
Parts Required
None
Aircraft System and Number
11—Landing Gear
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Jack the aircraft up or weight the tail so that the nose gear is clear of the ground.
CAUTION: 
Use a safety block under the forward hull if weighting tail.
2. Use a 7/16 wrench to remove the two AN4C11A bolts on either side of the NLG fork.
3. Slide the wheel assembly out of the fork.
4. Remove the ICA011894 spacer and AV-ICON-002 axle.
5. Proceed to section “Nose Wheel Tire Leak” to add sealant to the Nose Wheel.
6. Proceed to the Beringer Wheel and Brake Maintenance Manual if doing further work on the wheel.
Verification Method
The procedure is complete when the nose landing gear wheel has been removed.