Remove Parachute Egress Panel
100714-00
Use the following procedure to remove the Parachute Egress Panel.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Plastic Scraper
Parts Required
None
Aircraft System and Number
16—ICON Parachute System (IPS)
Safety Equipment
As Needed
Consumables
None
Task Instructions
2. Inspect the area around the IPS interface for any damage or wear. If any anomalies are detected, stop and report to ICON Aircraft.
3. Inspect the parachute egress area for any cracks or displacement of the bond between the fuselage and the IPS egress panel.
4. Use a plastic scraper to cut into, and pry apart, the bond between the IPS Egress Panel and the fuselage of the aircraft.
5. Remove the IPS Egress Panel.
Warning:
Handle the BRS Recovery System with extreme care. Injury and property damage may occur if BRS Recovery System is fired accidentally. Aircraft will render it and the aircraft unusable until the factory can service it. Do not fire it on the ground. Install the detent pin with “REMOVE BEFORE FLIGHT” flag into the activation handle before further inspection.
6. Inspect the front and rear harness with a flashlight and mirror for evidence of leakage, stains, or moisture.
7. Check for dents, breaks, and/or corrosion of metal components.
8. Inspect condition and tension of the parachute retaining straps, straps should be taut. Check for chaffing where straps go through mounts.
9. Check routing and connection of all harness traps and security of bolts and locknuts.
10. Ensure mounting screws are tight.
11. After the inspection is complete, remove the detent pin with the “REMOVE BEFORE FLIGHT” flap from the activation handle.
Verification Method
Panel has been removed.
Parent topic