ICON A5 MM : Instruments (and Avionics) : ADS-B GPS System : Maintenance Instructions : Remove ADS-B GPS Receiver
Remove ADS-B GPS Receiver
100489-00
Use this procedure to remove the ADS-B GPS Receiver. Aircraft prior to ASN 00110 may not have the ADS-B Out system installed. The ADS-B Out system requires that TT22 Transponder software is V2.13 or greater and TC20 Control Head software is V1.14 or greater. This task is applicable to the Garmin 796 configuration only.
Applicable Aircraft Serial Numbers
00110+ (Varies prior to ASN 00110)
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
ICA013692 (RECEIVER, GPS, TSO-C199)
Aircraft System and Number
10—Instruments (and Avionics)
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Locate the GPS RECEIVER on the LH Fuselage Skin, forward of the rudder pedals.
2. Disconnect wire harness D9119P.
3. Disconnect the coax ADS-B GPS Antenna connector.
4. Loosen the lock nuts and washers securing the GPS RECEIVER to the LH Fuselage Skin. Salvage the hardware. Remove the GPS RECEIVER.
Verification Method
GPS RECEIVER has been removed.