ICON A5 MM : Recommended Inspections : General Inspection Tasks : Cockpit Panels Removal and Installation : Remove Autopilot (AP) Control Panel
Remove Autopilot (AP) Control Panel
100494-00
Use the following procedure to remove the Autopilot (AP) control panel.
Applicable Aircraft Serial Numbers
00139+ (Applicable to the Autopilot Configuration Only)
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
NA
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. G3X Only--Remove Autopilot blank from center stack bezel by unclipping RH side first and pushing LH side out of face of center stack bezel. (Figure 15)
AP Only
2. Remove the six screws and six threaded inserts from the radio stack bezel. (Figure 14)
3. Remove the controller from the bracket. (Figure 13)
4. Remove trim position indicator. (Figure 10 Figure 11)
AP and G3x
5. Remove threaded inserts from radio stack bezel. (Figure 9)
Verification Method
Procedure is complete when AP control panel can be removed.