Corrosion Inhibitor Application
100557-00
After aircraft has been rinsed, an application of a water-displacing, corrosion inhibiting oil such as Corrosion Zero, LPS 3®, or CRC Marine Heavy Duty™ can be used.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
No
Aircraft System and Number
NA
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Apply corrosion inhibiting oil liberally to the metal parts of the aircraft.
2. After application, wipe away any excess oil with a rag or paper towel.
3. Use the list below as an application guide.
a. Nose gear fork and steering pivot assembly
b. Nose gear aft door retraction linkages
c. Nose gear self-centering gas spring and cam
d. Nose gear retraction bellcrank and drag link
e. Nose gear leg pivot, forward door pivot, and spring
f. Main gear axle and brake caliper
CAUTION:
Do not apply oil to the brake disk or pads.
g. Water rudder hinge, sector, and retraction cable
h. Air rudder lower hinge and drive lugs
i. All HT tip joint metal parts
j. All wing fold metal parts
k. Canopy latch
Verification Method
The task is done when all steps are complete.
Parent topic