Wing Extend Procedure
100627-00
Use the following procedure to extend the wing.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
15—Wing Fold Mechanism
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Set the parking brake or chock the wheels of the aircraft.
2. Inspect the condition of wing fold joint mechanism and ensure that the pins and sockets are clean and free of wear.
3. Ensure red wing lock handle is seated in the down (90 degrees) position.
4. Place forward hand on wing tip handle, rear hand underneath the trailing edge of the wingtip.
5. Using lower hand, release the release pin and lower wing to carry position.
Note:
Be prepared to hold the weight of the wing when the release pin is pushed. Failure to hold the wing up may result in the wingtip contacting the ground, causing structural damage.
6. Pull the wing aft to the stop approximately 19 inches.
Note:
Ensure proper vertical alignment so as to avoid impacting the Seawings™ platform with flap trailing edge.
7. Walk the wing forward with the leading edge pointed upwards until it is in the forward position.
8. Rotate wing leading edge forward 90 degrees so the wing is in the horizontal position.
9. Line up wing with fuselage, ensuring both fore/aft and up/down position is correct.
10. Push wing in to the stop, noting that slight fore/aft and vertical motion may be required to fully seat wing.
11. Immediately rotate the red wing lock handle into the locked position.
Note:
If wing is not fully seated, wing lock handle will not latch in the stowed position.
Verification Method
Verify wing lock handle is fully latched and the cockpit annunciators are extinguished.
Parent topic
Related references