Wing Hang Pin Replacement
100632-01
Use the following procedure to replace the left hand, right hand, or both wing hang pins.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
91732A213 (HELICOIL)
ICA013760 (WING HANG PIN)
Aircraft System and Number
14—Wing
Safety Equipment
As Needed
Consumables
LOCTITE® 243™
Task Instructions
1. Use a 5/16 wrench to remove the wing hang pin from its receptacle in the horizontal tail, turning it like a bolt.
2. If during removal, Helicoil was damaged then follow the step below:
a. Remove damaged Helicoil.
b. Replace insert (91732A213): Place insert onto installation tool and drive it a quarter to half-turn below the material’s surface.
3. Install new wing hang pins (ICA013760) into the Horizontal Tail. Apply LOCTITE® 243™ to the threads of the replacement pin and thread it into the receptacle in the horizontal tail. Torque to 150 in-lbs.
Note:
Do not apply any Tef-Gel or Lubricant to the new wing hang pins.
Verification Method
The procedure is finished when all the steps have been completed.
Parent topic