Remove OAT Sensor
100605-00
Use the following procedure to remove the OAT sensor.
Applicable Aircraft Serial Numbers
00139+
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
10—Instruments (and Avionics)
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove cable tie securing the D9141P to cable tie block.
2. Disconnect connector D9141J of OAT sensor from D9141P on harness. Verify locking features of connector are disengaged.
3. Remove cable tie and route D9141J connector through the center wing rib.
4. Remove nut and washer. Retain nut for installation of new OAT sensor.
5. Remove OAT sensor.
Verification Method
Install new OAT sensor.
Parent topic