ICON A5 MM : Propulsion : Engine : Engine General Maintenance : Engine Mount Installation
Engine Mount Installation
100149-00
Use the following procedure to install the engine mount.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Heavy
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
13—Propulsion
Safety Equipment
As Needed
Consumables
LOCTITE®243™
Task Instructions
1. Install the engine mount as shown in Figure 363. The single long screw is a 941487. The five short screws are 840947. The washers are Nord-Lock NL10SS. Apply LOCTITE®243™ to the screw threads on installation and torque each of the six screws to 30 ft-lbf.
Note: 
If spacers were removed and saved during the engine mount removal, discard and do not reinstall.
2. Install the thermostat-radiator coolant hose where it attaches to the lower-right fitting at the thermostat (Figure 362).
3. Connect the two coolant hoses where they attach to the lower water pump fittings as shown in the upper image of Figure 361. Rotate the hose clamps on the hoses so the tabs are on top as shown in the lower graphic in Figure 361 (this prevents tabs contacting the firewall during engine installation).
Verification Method
The procedure is complete when all the steps have been finished and the engine can be installed. (Install Engine)