Aera 796 GPS Mount and Radio Stack Bezel Installation
100245-01
Use the following procedure to install the GPS mount and Radio stack bezel. This task is applicable to the Garmin 796 configuration only.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
ICA008105 (MOUNTING MODULE, GARMIN GPS)
ME000355-NS796 (RADIO STACK, SUBASSY)
Aircraft System and Number
05—Equipment and Furnishings
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Install the GPS mount and radio stack bezel at the same time. Do this by first interlocking the two parts together. Then, while holding the lower edge of the radio bezel away from the center console, engage the tabs at the upper edge of the GPS mount and push the assembly into place.
2. Connect the electrical harness D9011J to the instrument panel cross beam. Connect the transponder harness (D9068P) and the Radio harness (D9058P). Connect the static line to the transponder control head.
3. Install the two 8-32 mounting screws in the GPS mount and the four 8-32 screws that mount the radio bezel, torquing all to 13 in-lbf.
Verification Method
Confirm center stack and all components are secure.
Turn on master switch. Confirm all switches are operating properly and activating their associated function.
Perform a transponder correspondence test. If the control unit was replaced, configure the transponder. See 00560-00-AQ--TRiG TT21/TT22 Mode S Transponder Installation Manual.
Ensure VHF radio header screen turns on and is operable. Test radio transmission and receiving with an external radio.
Parent topic
Related tasks