ICON A5 MM : Equipment and Furnishings : Equipment and Furnishings General Maintenance : Aera 796 GPS Mount and Radio Stack Bezel Removal
Aera 796 GPS Mount and Radio Stack Bezel Removal
100246-01
Use the following procedure to remove the GPS mount and Radio stack bezel. This task is applicable to the Garmin 796 configuration only.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
05—Equipment and Furnishings
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove the Garmin Aera 796 GPS® if installed.
2. If the center console bucket and throttle bezel are still in place. (Center Console Bucket Removal) (Throttle Handle and Bezel Removal)
3. Use a T15 Torx driver to remove the four 8-32 screws that attach the radio stack bezel.
4. Lift up on the bottom edge of the radio stack bezel, pulling it away from the center console and pivoting it about its upper edge. The tabs on the upper edge of the bezel of the GPS mount to rotate outward in a similar fashion, releasing the tabs at its top edge.
5. Remove the radio stack bezel and disconnect the electrical harness D9011J from the instrument panel cross beam. Disconnect transponder harness (D9068P) and the Radio harness (D9058P). Disconnect the static line to the transponder control head to completely release radio stack bezel.
6. Unfasten the Garmin GPS mounting module using a T15 Torx driver to remove the two 8-32 screws. Remove the GPS mount.
Verification Method
The procedure is complete when the GPS mount and radio stack bezel has been removed.