ICON A5 MM : Equipment and Furnishings : Equipment and Furnishings General Maintenance : Throttle Handle and Bezel Removal
Throttle Handle and Bezel Removal
100612-00
Use the following procedure to remove the throttle handle and bezel.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools
No
Parts Required
None
Aircraft System and Number
05—Equipment and Furnishing
Safety Equipment
As Needed
Consumables
LOCTITE®243™
Task Instructions
1. Remove center console bucket. (Center Console Bucket Removal)
2. Remove 2X Screws which secure the handle grips using a 9/64 hex wrench. Separate the two halves of the handle to remove it from the throttle lever. Retain all fastening hardware and handle components. Figure 66
Figure 66. Throttle Handle Screws
3. Remove the standoff that is inserted into the throttle lever. Retain hardware. Figure 67
Figure 67. Standoff Removal
4. Remove throttle bezel along with the hour meter (connectors T9114(+) and T99105(-)). Label each wire to ease reinstallation. The forward part of the bezel has two indexing tabs that slide out from the center stack and center console panel assembly.
Figure 68. Throttle Bezel Removal
Verification Method
Procedure is complete when the throttle handle and bezel is removed from the aircraft.