ICON A5 MM : Landing Gear : Landing Gear General Maintenance : Check Landing Gear Retracted Position
Check Landing Gear Retracted Position
100275-00
The following section contains the information required to evaluate the rigging of the landing gear components in the retracted position.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Wing Jack Point Adapter—ICA009750
Parts Required
None
Aircraft System and Number
11—Landing Gear
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Jack the aircraft using the built-in jack points. (796 Empty Weight and CG Measurement While on Jackpoint Scales)
2. Initiate gear retraction.
3. Verify landing gear indication moves to “In Transit” while actuators are working.
4. Once stopped, verify blue landing gear up indication has been obtained.
5. View the actuation process and verify the main landing gear connects with the up-stop. The up-stops are located near the wheel well, underneath the Seawings™ platform.
6. Verify that the landing gear has fully retracted and the nose gear doors have withdrawn completely to provide a smooth closed outer surface.
7. Extend landing gear.
8. Turn off master switch.
9. Lower the aircraft and remove jacks.
Verification Method
Verify that each check is passed successfully.