Bilge Pump Debris Removal
100278-00
The following section includes information necessary to check the bilge pump for debris.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
04—Environmental Control (Utility Systems)
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove the 4 Torx #20, 10-32 thread flat head screws of the right baggage floor panel.
3. With a flashlight, place the light beam in the middle-rear of the fuel bladder installation looking down to the bottom of the fuselage.
4. Inspect the bilge pump. If there is any debris, gently remove from around the screen portion of the pump.
6. Tighten and secure the 4 Torx #20, 10-32 thread flat head screws.
Parent topic
Related references