ICON A5 MM : Airworthiness Limitations : Condition Inspections and 100-Hour Inspections : Condition and 100-Hour Inspection—Aft Fuselage and Empennage
Condition and 100-Hour Inspection—Aft Fuselage and Empennage
100284-00
Correct all unsatisfactory items prior to flight S=Satisfactory, U=Unsatisfactory
S
U
Comments
1
Remove two inspection panels and inspect seals
2
Check horizontal tail for security and condition
3
Check horizontal tail tips for security and condition (Measure Horizontal Tail Tip Anti Rotation Pin Wear)
4
Check horizontal tail attach points for security, evidence of motion, damage
5
Inspect outboard elevator and rudder attach points and verify hardware is secure
6
Inspect hinges/rod ends for attachment and free play
7
Inspect empennage skin for damage/delaminations
Verify no lateral play on elevator
8
Verify no more vertical play/slop on air rudder than 0.018”
9
Inspect yaw cable tension (Inspect Yaw Cable Tension)
10
Inspect pitch cable tension (Inspect Pitch Cable Tension)
11
Inspect pitch trim system, mounting bracket, and linkage for security, proper rigging, and wear
12
Inspect all control cables, hinges, pulleys, pushrods, bellcranks
13
Check the water rudder for excessive play. There should not be more than 0.040” play vertically
14
Check for corrosion
15
Inspect all control stops for condition and security and proper rigging
16
Static ports clear
17
Inspect yaw rigging (Inspect Yaw Rigging)
18
Inspect pitch rigging (Inspect Pitch Rigging)
19
Reinstall tail access panels