Install Center Wing EPDM Foam
100330-00
Use the following procedure to install the EPDM foam on the center wing.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training
No
Special Tools Required
None
Parts Required
93725K52 (EPDM FOAM, ADHESIVE BACKED, .125X.375X600)
Aircraft System and Number
14—Wing
Safety Equipment
As Needed
Consumables
TT-I-735A or equivalent (ISOPROPYL ALCOHOL)
Task Instructions
1. With the wing folded, prepare bonding surface of center wing:
a. Clean bonding surface with mild soap and water solution.
b. Dry surface.
c. Wipe surface with ISOPROPYL ALCOHOL.
d. Dry surface using a lint-free cloth.
2. Apply foam seal (93725K52) to tangency of center wing skin ±.100” (inch) on fuselage side.
3. Locate ends of the seal according to the dimensions shown in reference to the trailing edge. See Figure 447 and Figure 448.
Figure 447. Right Side Shown
Figure 448. Left Side Shown
Verification Method
Once the EPDM foam is installed on the center wing, the task is complete.
Parent topic