ICON A5 MM : Propulsion : Engine : Oil System : Maintenance Instructions : Install Oil Tank
Install Oil Tank
100361-01
Use the following instructions to install the oil tank.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
TY24MX (CABLE-TIE, NYLON 6-6, 30LB)
J1508F-88 (CLAMP, WORM DRIVE, .50X5.50)
Aircraft System and Number
13—Propulsion
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Secure the oil tank to the oil tank mount in the orientation shown in Figure 404 using 2X CLAMP, WORM DRIVE. Torque to 25-30 in-lbs.
Note: 
The oil tank must maintain a minimum clearance of .25 inches from the firewall.
2. Remove any plugs and install oil hose at thermostat. Torque to 150-250 in-lbs.
3. Remove plugs and install oil return hose at “IN” port of oil tank. (Figure 360) Torque B nut to 300-350 in-lbs if using Method A or to 290-330 in-lbs if using Method B. (Figure 356)
CAUTION: 
Ensure a back-up wrench is used on the oil tank fitting while torqueing. Damage to oil tank may occur if it’s not used.
4. Secure reservoir-thermostat hose to the cable tie mount using a CABLE-TIE.
5. Secure purge hose to the engine mount using a CABLE-TIE. (Figure 360)
6. Fill the oil tank with correct quantity and type of oil. (Engine Oil Check and Replenish)
7. Purge the engine oil system per the latest Maintenance Manual: (Line Maintenance) For Rotax Engine Type 912 i Series.
8. Install top engine cowl. (Install Engine Cowlings)
Verification Method
Complete the engine test run. (Engine Test Run)