ICON A5 MM : Propulsion : Engine : Engine General Maintenance : Install Engine Cowlings
Install Engine Cowlings
100335-02
Use the following instructions to install top engine cowl, fan shrouds, and exhaust fairings.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
13—Propulsion
Safety Equipment
As Needed
Consumables
ICA012078 (LUBRICANT, GENERAL PURPOSE) Tef-Gel®
Task Instructions
1. Install LH fan shroud. (Figure 353)
a. Apply LUBRICANT and install one countersunk screw with a #15 Torx driver.
b. Apply LUBRICANT and install three #10-32 button head screws with #20 Torx driver.
c. Torque to 26 in-lb.
Figure 353. LH Fan Shroud Installation
2. Install RH fan shroud. (Figure 354)
a. Apply LUBRICANT and install two countersunk screws with a #15 Torx driver.
b. Apply LUBRICANT and install four #10-32 button head screws with #20 driver.
c. Torque to 26 in-lb.
Figure 354. RH Fan Shroud Installation
3. Install the LH and RH muffler fairing with nine button head screws using a #20 Torx driver. Apply LUBRICANT and torque to 26 in-lb.
4. Position the top engine cowl over the engine and connect the ELT and transponder coax connectors.
a. Transponder - D9008J2
b. ELT - D9103J
c. G3X ADS-B - D9156J (G3X configuration only.)
5. Use a #15 Torx driver to secure the top engine cowl with 16 1/4-turn fasteners.
Verification Method
The task is complete when all engine cowlings and exhaust fairings have been installed.
For Aera 796 aircraft, see Verification Method steps 1 and 4 from Install ADS-B GPS Antenna for GPS system.
For G3X aircraft, see Verification Method from Install G3X ADS-B Antenna for GPS system.
Perform ELT unit self-test according to SELF TESTS of Section 9 of ACK Technologies Inc. Model E-04 ELT Installation/Operation Manual, or ELT Battery Self Test
Note:
Reference SAFO 17002 as needed within performing transponder maintenance tasks.
For Aera 796 aircraft, perform a transponder functional test for transmission on 121.5 MHz and 406 MHz. If the control unit was replaced, configure the transponder. See 00560-00-AQ--TRiG TT21/TT22 Mode S Transponder Installation Manual.
For G3X aircraft, perform a transponder functional test for transmission on 121.5 MHz and 406 MHz. If the control unit was replaced, configure the transponder. See 190-01499-10 Garmin GTX 34R/45R Installation Manual and 190-01115-01 Garmin G3X/G3X Touch Installation Manual.