ICON A5 MM : Landing Gear : Main Landing Gear : Maintenance Instructions : Main Landing Gear (MLG) Wheel and Axle Removal
Main Landing Gear (MLG) Wheel and Axle Removal
100406-00
Use the following procedure to remove the MLG wheel and axle.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
ICA009749 (WING HARD JACKING POINT)
Parts Required
None
Aircraft System and Number
11—Landing Gear
Safety Equipment
As Needed
Consumables
None
Note: 
During the following procedures, do not actuate the brake system.
Task Instructions
2. Remove the safety wire that secures the brake rotor to the MLG wheel.
Figure 327. Wheel/brake rotor detail.
3. Remove MLG wheel seal cap.
4. Remove cotter pin, MLG wheel nut, wheel, and spacer.
Figure 328. Wheel nut detail.
5. Remove brake rotor from caliper and store in a clean location.
6. Remove the four AN4C16A bolts that secure the MLG axle to the MLG leg. Remove the reinforcement plate from the MLG leg. Retain hardware for reinstallation.
7. Separate the axle from the leg. Remove the countersunk screws on the inboard side of the axle to disconnect the brake caliper from the axle. It is permissible for the caliper to dangle from the landing gear leg. Retain hardware for reinstallation.
Verification Method
Task is complete when wheel and axle are fully removed from the leg.