ICON A5 MM : Instruments (and Avionics) : Instruments and Avionics General Maintenance : Overhead Console Component Replacement
Overhead Console Component Replacement
100443-00
Use this procedure to replace any indicated component mounted in the overhead console.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
10—Instruments (and Avionics)
Safety Equipment
As Needed
Consumables
None
Find Number
Part Number
Name
003
M81714/67-02
Terminal Block, Mounting Track
004
W23-X1A1G-30
Circuit Breaker, 30A
005
ICA006179
Horn, Stall Warning
006
ICA012253
SWITCH, REMOTE, ELT TEST/RESET
007
ICA012255
HORN, ELT AUDIO ALERT
008
E-04-10-3
Cable, Audio Alert, ELT
011
ICA010402
Potentiometer, 10K Map Light
013
ICA010373
Driver Module, OHC
014
ICA010374
Illuminator Light, OHC, Instr PNL, Red
015
ICA010376
Illuminator Light, OHC, White
021
96817A890
Screw, Torx Panhead, 18-8, M2.5X0.95
022
TY23MX
Cable-tie, Nylon 6-6, 30lb, 5.50, TY-RAP
023
ICA010401
Potentiometer, 10K, Instrument Panel Lighting
024
ICA010403
Potentiometer, 10K, OHC Lighting
025
ICA010404
Potentiometer, 10K, Center Stack Lighting
031
ICA010375
Illuminator Light, OHC, Ctr Stk, Red
Task Instructions
1. Remove the four light control knobs from the overhead console by pulling each down and off their D-shafts.
2. Remove the overhead console bezel by pulling down on its forward edge, disengaging two spring clips. Disengage the two indexing tabs at the aft edge of the bezel, then remove the bezel.
3. Disconnect the D9078P and D9079J wire harness connectors and the ELT remote cable connector (telephone-type) from the overhead console.
4. Using a ball end 3/32 hex key, remove fuel shut off valve selector knob.
5. Detach the overhead console by using a T15 Torx driver to remove the six 96710A318 pan-head screws that secure it (the screws thread into nutplates).
6. Place the overhead console on a clean work surface and replace any damaged or faulty component indicated in the figure and table below.
7. Use the graphic and associated parts list table to select the appropriate replacement components and then remove and replace the components.
8. Using a ball end 3/32 hex key, install fuel shut off valve selector knob.
9. After component replacement, install the overhead console with the six 96710A318 pan-head screws. Watch out for pinch points at the screw bosses to avoid damaging wiring. Torque each screw to 13 in-lbf.
10. Connect the D9078P and D9079J wire harness connectors and the ELT phone connector.
11. Install the overhead console bezel by engaging the tabs at its aft edge, then swinging the forward edge up until the spring fasteners snap into place.
12. Push the four light control knobs onto their D-shafts.
Verification Method
Check the correct function of a replaced component.