Removal of Wing Tip Lights
100486-00
These instructions should be used to remove the wing tip lights.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
03—Electrical System
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Using a T15 Torx screwdriver, remove the retention screw on each leading edge and tail edge light as needed.
Note:
If the retention screw is not being replaced, ensure the O-ring remains on it.
2. Detach light from aircraft and disconnect the light’s wire harness connectors.
a. Disconnect D90002J1 and D9002P2 on LIGHT, POSITION & STROBE, LE-LH from D9002P1 and D90002J2 on aircraft wire harness, respectively.
Note:
b. Disconnect D9003P on LIGHT, POSTION & STROBE, TE-LH from D9003J on aircraft wire harness.
c. Disconnect D9006J1 and D9006P2 on LIGHT, POSITION & STROBE, LE-RH from D9006P1 and D9006J2 on aircraft wire harness, respectively.
d. Disconnect D9007P on LIGHT, POSITION & STROBE, TE-RH from D9007J on aircraft wire harness.
Figure 52. Leading edge light assembly, LH
Figure 53. Trailing Edge Light Assembly, LH
Verification Method
The task is complete when the light is fully removed from the aircraft. Use Installation
of Wing Tip Lights to reinstall.
Parent topic