ICON A5 MM : Electrical System : Wing Tip Lights : Maintenance Instructions : Installation of Wing Tip Lights
Installation of Wing Tip Lights
100329-00
These instructions should be used to install the wing tip lights.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
ICA013955 (LIGHT, POSITION & STROBE, LE-RH)
GTV-IC1600-0-AJ (LIGHT, POSITION & STROBE, TE-RH)
ICA013956 (LIGHT, POSITION & STROBE, LE-LH)
GTV-IC1600-1-AJ (LIGHT, POSITION & STROBE, TE-LH)
8-32x5-8TXFL82-316SS-BUN (SCREW, FL BUNA-N, 8-32x5-8T)
ICA014012 (SCREW, TORX, BUTTON HEAD, BUNA SEAL, 300SS, 8-32X.625)
Aircraft System and Number
03—Electrical System
Safety Equipment
As Needed
Consumables
LOCTITE 243
Task Instructions
1. Inspect the interior of the wing tip for water, debris, or anything else amiss and correct any issues.
2. Inspect the surfaces where the light’s seal will contact the wing, ensuring that it is undamaged and clean.
Note: 
If installing a trailing edge (TE) light, remove the adhesive backing from the included seal (Figure 53) prior to installation.
3. For Leading Edge Lights only: trim the foam to .110” thick, ±.020” if replacing with a new light.
4. Connect the light’s wire harness connectors.
a. For the LH Trailing Edge light, connect D9003P on light to D9003J on aircraft wire harness.
b. For the RH Trailing Edge light, connect D9007P on light to D9007J on aircraft wire harness.
c. For the LH Leading Edge light, connect D9002J1 and D9002P2 on light to D9002P1 and D9002J2 on aircraft wire harness respectively.
d. For the RH Leading Edge light, connect D9006J1 and D9006P2 on light to D9006P1 and D9006J2 on aircraft wire harness respectively.
5. Attach light to wing.
a. For Trailing Edge Lights use SCREW, BUNA-N, 8-32x5-8 with LOCTITE 243. Verify light is seated and torque screw to 15-20 in-lbs with a T15 Torx drive
b. For Leading Edge Lights attach light to wing using ICA014012 SCREW, TORX, BUTTON HEAD, BUNA SEAL, 300ss, 8-32X.625 and secure with LOCTITE 243. Verify light is seated and torque screw to 15-20 in-lbs with a T15 Torx drive.
Note: 
If not in place, install the trailing edge light fences. (Wing Trailing Edge Light Fence Replacement)
Verification Method
The task is complete when the light is secure.