ICON A5 MM : Equipment and Furnishings : Equipment and Furnishings General Maintenance : Remove G3X Center Stack Bezel
Remove G3X Center Stack Bezel
100749-00
Use the following procedure to remove the G3X center stack bezel.
Applicable Aircraft Serial Numbers
00123+ (Applicable to G3X Configuration Only)
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
05—Equipment and Furnishings
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove G3X display unit.
a. Remove 4x 7/64 hex screws.
b. Disconnect Garmin wiring harness D9149P.
c. Remove Garmin display unit.
2. Remove Center Stack
a. Remove the center console bucket and throttle bezel if necessary. (Center Console Bucket Removal)(Throttle Handle and Bezel Removal)
b. Remove 6x Torx 6-32 screws on center stack bottom of center stack, sides of center stack, and top of center stack that connect the center stack to the G3X housing.
c. Disconnect D9011J
d. If AP controller is installed, disconnect TB9010.
e. Remove center stack.
Verification Method
Procedure is complete when center stack bezel has been removed.