Remove Connector/Terminal
100496-00
Use the following procedure to remove any spade (disconnect/Push-On) or ring terminal.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Wire Stripper
Parts Required
None
Aircraft System
03—Electrical System
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Identify connector requiring replacement and confirm connector part number.
2. Cut wire as close as possible to old connector and discard connector.
Note:
Verify the wire will not be pulled tight after the installation of new connector. If the wire will be taught after installation of new connector, the component may need to be replaced.
3. Strip wire insulation as required to properly install new connector.
Verification Method
See the Note on Step 2 for verification.
Parent topic
Related tasks