ICON A5 MM : Horizontal Tail : Horizontal Tail General Maintenance : Horizontal Tail Removal and Installation : Remove Horizontal Tail Tip Lock Switches
Remove Horizontal Tail Tip Lock Switches
100511-00
Use the following procedure to remove the two horizontal tail tip lock switches.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
09—Horizontal Tail
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove horizontal tail tip access panel. Keep screws for reinstallation. (Figure 188)
Figure 188. Remove Horizontal Tail Tip Access Panel (LH shown, RH opposite)
2. Remove the 4 screws, washers, and nuts securing limit switches. Set aside for installation. (Figure 189)
Figure 189. Remove Screws Securing Switches
3. Unplug and remove limit switches from wiring harness. (Figure 190)
Figure 190. Remove Switches From Wiring Harness
Verification Method
Once the two limit switches are completely removed from horizontal tail, this task is complete.