ICON A5 MM : Electrical System : Electrical System General Maintenance : Remove Individual Center Stack Bezel Components (Aera 796)
Remove Individual Center Stack Bezel Components (Aera 796)
100745-00
Use the following procedure to remove the individual center stack bezel components of Aera 796 equipped aircraft.
Applicable Aircraft Serial Numbers
00123+
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
03—Electrical System
Safety Equipment
As Needed
Consumables
Masking Tape
Task Instructions
1. Remove center stack bezel. (Aera 796 GPS Mount and Radio Stack Bezel Removal)
2. Remove rocker switch for lights and bilge pump.
a. Disconnect spade terminal connectors from back of switch.
b. Unscrew plastic retaining nut.
c. Remove switch.
3. Remove flap lever.
a. Remove 4-40 hex set screw on bottom of flap selector switch knob.
b. Remove retaining nut and locking washer for flap selector switch.
c. Remove flap switch.
d. Disconnect electrical connector.
4. Remove landing gear switch.
a. Remove set screw on landing gear switch knob.
b. Remove landing gear switch knob.
c. Pry plastic overlap from center stack bezel. Using masking tape around center to prevent damage.
d. Remove retaining nut and locking washer.
e. Remove landing gear switch.
f. Disconnect electrical connector.
5. Remove landing gear position indicator.
a. Remove landing gear switch.
b. Remove electrical connector from indicator circuit board.
c. Remove 2 screws on back of indicator circuit board.
d. Remove indicator circuit board.
6. Remove heater knob.
a. Remove set screw on plastic heater knob.
b. Pull knob from switch shaft.
c. Remove retaining nut and washer.
d. Remove heater knob switch.
e. Disconnect electrical connector.
7. Remove water rudder switch.
a. Unscrew plastic nut on back side of switch.
b. Remove switch.
c. Disconnect electrical connector.
8. Remove LED indicator (bilge and water rudder)
a. Pull LED out of socket in center stack bezel.
b. Disconnect electrical connector.
9. Remove Trig VHF Radio and transponder
a. Remove 6x screws holding radio bracket to bezel.
b. Disconnect all electrical connectors.
c. Remove radio and transponder.
10. Remove trim indicator (Garmin Aera 796)
a. Remove 4 screws on back of unit.
b. Remove indicator.
c. Disconnect electrical connector.
Verification Method
Procedure is complete when desired components have been removed.