ICON A5 MM : Wing : Wing Lock : Maintenance Instructions : Wing Lock Handle Removal
Wing Lock Handle Removal
100637-00
Use the following procedure to remove the wing lock handle.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
14—Wing
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Fold wing. (Wing Fold Procedure)
2. Unlatch the wing from the horizontal tail and pull it fully aft. Support it in this position by hanging the wing tip with straps from an engine hoist or other suitable arrangement.
3. Use a T15 Torx drive to remove the three 8-32 flush-head screws that attach the wing lock handle mounting boss to the fuselage BL38 Rib.
4. Remove the wing lock handle and attached components from the fuselage BL38 Rib by rotating the handle far enough to withdraw the wing lock cross pins from the pin sockets.
5. Proceed with the following further disassembly steps as necessary:
a. There are two link rods attached to the lock handle with a total of four ICA008144 pivot pins and 98410A110 retaining rings. Remove each of these, making note of the pin orientation.
b. Remove the ICA011333 retaining ring from the shaft of the mounting boss (see Figure 460)
c. Remove the spacer, wave spring, and plastic washer from the shaft.
d. Slide the mounting boss out of the handle.
e. Press the wing lock bushing out of the handle if necessary, making note of its orientation.
f. Use a slot-head screwdriver to remove thee spring detent from the handle.
Figure 460. Wing Lock Handle
Verification Method
The procedure is complete when the wing lock handle has been removed.