Battery Removal and Installation—Configuration A
100060-00
The Concord RG-25XC, 12V, 24Ah or 11Ah main aircraft battery is removed and installed by using the procedures given.
Applicable Aircraft Serial Numbers
00001-00153
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
CONCORD RG-25XC, 12V, 24 AH BATTERY
or
ICA014884 (BATTERY, VRLA, 12V 11AH)
8997K53 POLYURETHANE STRIP
Aircraft System and Number
03—Electrical System
Safety Equipment
As Needed
Consumables
None
Task Instructions
2. Disconnect the cabling from the negative battery terminals.
3. Disconnect the cabling from the positive battery terminals.
4. Remove the Battery Hold Down bracket nuts and bracket with a 7/16 wrench.
5. Remove the battery from the battery box.
Battery Installation
6. Install 8997K53 Polyurethane strip around the perimeter of the battery flush with the base. Cut to length needed to allow seam gap of less than 1.5”.
7. Install the battery into the battery box with terminals toward the right side of the aircraft.
8. Install the Battery Hold Down bracket with nut and washer as removed. Hand tighten the nuts ensuring the bracket sits evenly across the battery then torque each side to 44 in-lbf with a 7/16 wrench.
9. Reconnect the battery terminals in the following order:
a. Positive Terminal Connectors T9181, T9054.
b. Negative Terminals Connectors T9069, T9074, T9076, T9182.
Verification Method
Turn the master switch on a verify that all electrical and avionics systems power up and function correctly.
Parent topic
Related tasks