ICON A5 MM : Instruments (and Avionics) : Instruments and Avionics General Maintenance : Remove Instrument Cluster
Remove Instrument Cluster
100512-00
Use the following to remove the instrument cluster to perform maintenance on instrument gauges or annunciator panel.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
10—Instruments (and Avionics)
Safety Equipment
As Needed
Consumables
None
A pitot-static-AOA leak test is required whenever a pitot-static or AOA tube is disconnected. (Pitot Static Leak Check Operation)
Task Instructions
1. Remove cluster hood shell by pulling upon the aft side and sliding hood towards aft aircraft.
2. Remove four #8-32 cluster attachment screws. Figure 222
Note: 
Retain removed hardware for re-installation.
Figure 222. Instrument Panel Mount Attachment Detail—Exploded View
3. Disconnect all electrical connections to the instrument cluster. Take note of wiring harness layout for re-installation.
4. Disconnect two static and one pitot tube from airspeed indicator and altimeter.
5. Remove cluster from aircraft.
6. Remove cluster bezel by removing 10 #6-32 mounting panel attachment screws. Figure 223
Figure 223. Instrument Panel Bezel Detail—Aircraft Rear View
Verification Method
The task is complete when the instrument cluster bezel has been removed from the instrument cluster.