Remove Landing and Taxi Lights
100515-00
Use the following instructions to remove the landing and taxi lights.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
03—Electrical System
Safety Equipment
As Needed
Consumables
None
Figure 56. Landing and Taxi Lights Installation, RH (LH Opposite)
Task Instructions
1. Remove top instrument panel. (Right Instrument Panel Top Panel Removal)(Left
Instrument Panel Top Panel Removal)
2. Unplug D9033P connector on main wire harness from receptacle on LH light.
3. Unplug D9034P connector on main wire harness from receptacle on RH light.
4. Remove 5 8-32 nuts and washers attaching the landing and taxing light to the front fuselage. Keep for re-installation.
5. If installing ICA014417 or ICA014418, remove forward-most upper click bond stud as it will interfere with the new bracket.
Figure 57. FWD and AFT Upper Click Bond Stud
Note:
The AFT stud can also be removed as it will not be needed, but it will not cause interference if it is not removed.
6. Remove the LH and RH landing and taxi lights.
Verification Method
The task is complete when both landing and taxi lights have been removed.
Parent topic