ICON A5 MM : Electrical System : Landing and Taxi Lights : Maintenance Instructions : Install Landing and Taxi Lights
Install Landing and Taxi Lights
100352-00
Use the following instructions to install the landing and taxi lights.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
13 INCH POUND TORQUE WRENCH
Parts Required
ICA011034 (LIGHT, TAXI AND LANDING, RH)
ICA011035 (LIGHT, TAXI AND LANDING, LH)
or
ICA014417 (LIGHT, TAXI AND LANDING, RH)
ICA014418 (LIGHT, TAXI AND LANDING, LH)
ICA014268 (BRACKET, RH)*
ICA014390 (BRACKET, LH)*
2x ICA014414 OVERSIZED WASHER
3x NAS1149CN8324 #8 WASHER
5x MS21043-08 NUT
NUT, SLFLKG, RDC HEX, CRES, 8-32
WASHER, FLAT, CRES, #8, .032 THK, PSVT FNSH
Aircraft System and Number
03—Electrical System
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. *If installing ICA014417 or ICA014418, install two new brackets (ICA014268 and ICA014390).
2. Install LH and RH light assembly onto existing studs as shown using retained washers and nuts.
3. Torque nuts to 13 in-lbs. Check that hardware is secure.
4. Plug D9033P connector on main wire harness into receptacle on LH light.
5. Plug D9034P connector on main wire harness into receptacle on RH light.
6. Turn on the landing and taxi lights switch in the radio bezel to verify lights are working correctly.
Verification Method
This task is done when the landing and taxi lights are installed and working.