ICON A5 MM : Landing Gear : Landing Gear General Maintenance : Landing Gear Actuator Limit Switch Adjustment Procedure
Landing Gear Actuator Limit Switch Adjustment Procedure
100392-00
There are multiple configurations of actuators in the fleet currently. Please use applicable actuator part number and Figure 304 to identify whether his section is applicable to your aircraft actuator. If your actuator doesn’t match this part number/configuration refer to Landing Gear Actuator Limit Switch Adjustment Procedure. Use this procedure to adjust the limit switch on the desired actuator.
Applicable Actuator Part Number
ICA013160
ICA013161
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
11—Landing Gear
Safety Equipment
As Needed
Consumables
None
Figure 304. Landing Gear Actuator for ASN 00110+
Task Instructions
1. Unless already performed, remove any interior panels needed to gain access to the actuator. (Right Instrument Panel Top Panel Removal)(Removal and Installation of Inspection Panels and Fairings)
2. Jack the aircraft so that the landing gear is clear of the ground. (796 Empty Weight and CG Measurement While on Jackpoint Scales)
3. Use an open-end wrench to loosen the jam nut tightened against the limit switch adjustment saddle for the affected switch.
4. Use the thumb wheel to set the affected switch to the desired position.
5. Torque the jam nut to 20-24 in-lbs to secure the position of the limit switch.
6. Power up the aircraft, and actuate the landing gear to verify adjustment.
7. Repeat steps 3 thru 5 as needed until the landing gear is properly adjusted.
8. Replace the interior panels, extend the landing gear, and lower the aircraft off the jacks. (Right Instrument Panel Top Panel Installation)(Removal and Installation of Inspection Panels and Fairings)
Verification Method
Power up the aircraft, and actuate the landing gear to verify adjustment.