Rudder Pedals Remove and Redo
100555-00
Use this task to remove and redo the rudder pedal rigging.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
A&P
Task Specific Training Required
No
Special Tools Required
Protractor or inclinometer
Parts Required
ICA009509 Control Cable
ICA009510 Control Cable
MS51844-23 Sleeves
AN100C-4 Thimbles
MS24665-151 Cotter Pins
Aircraft System and Number
06—Flight Controls
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove existing rudder pedal cables. Cut cable just after the MS51844-23 swage sleeve and remove.
Figure 144. Rudder Pedal Cable Swage
2. With the rudder pedals in the middle position and rudder pedal arms 90° ± 1° relative to the rudder rails, route cable through the rudder arm “S” tube, sleeve, and cable.
Note:
Do not swage sleeve in this step.
3. Temporarily install the cable to the forward rudder rail mount. Install cable to the rudder pedal turnbuckles, set turnbuckles to the mid position of adjustment.
4. Remove slack from rudder pedal cables while maintaining 90° ± 1° at the rudder pedal arms. Mark the rudder cables.
5. Uninstall cable from the forward rudder rail mount.
6. Ensure the mark created in Step 4 is in the correct location.
7. Swage MS51844-23 sleeve.
8. Install the rudder pedal cables.
Figure 145. Rudder Pedal FWD Mount Cable Installation
9. Install the floorboard panels to the aircraft by locating them in position and pressing downward.
Verification Method
Perform the rudder pedal inspection procedure. (Inspect
Rudder Pedal Rigging)
Confirm correct rigging for entire yaw control system by performing the water rudder inspection procedure and the rudder inspection procedure.(Inspect Yaw Rigging)(Check Water Rudder Rigging)
Confirm that at the pedal movement maximum travel the primary stops in the horizontal tail are met first. The secondary stops, under the center console, should be met after cable tension has been applied.
Parent topic