ICON A5 MM : Recommended Inspections : General Inspection Tasks : Cockpit Panels Removal and Installation : Seat Pan Removal
Seat Pan Removal
100569-00
The following procedure is used to remove the seat pan.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
NA
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove seat back. (Remove Seat Back)
2. Cut the cable tie at the top of the control stick boot, then unzip boot’s zipper.
3. Remove the aft cockpit floor board on the appropriate side. (Remove Cockpit Floorboard)
4. Reaching underneath the seat pan, use a 1/2 wrench to remove the four attachment bolts and washers. The forward two bolts are AN5C5A and the aft two bolts are AN5C6A.
5. Turn the seat pan over and remove the rudder pedal release cable by loosening the jam nut nearest the cable end and running it off the threaded end of the housing. The cable can then be freed from the seat pan by passing the cable through the slot in the cable clip, then disengaging the cable’s free end from the release handle.
6. Remove the seat pan from the aircraft.
Verification Method
The task is complete when the seat pan has been removed.