ICON A5 MM : Equipment and Furnishings : Equipment and Furnishings General Maintenance : Seat Belt Replacement
Seat Belt Replacement
100567-01
Use the following procedure to remove and install the seat belts.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
200-US-121XX (SEAT BELT)
AN5C6A (BOLT)
ICA001942 (BUSHING)
ICA006812 (RH, LONGERON)
ICA006814 (LH, LONGERON)
2X NAS1149C06634 (WASHER)
MS21043-5 (NUT)
Aircraft System and Number
05—Equipment and Furnishings
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove the baggage floors and seat back panel on the side of the seat belt to be removed. (Baggage Floor Removal)(Remove Seat Back)
Note: 
Though not necessary, removal of the seat back and seat pan makes the following steps easier. (Seat Pan Removal)
2. Remove the seat belt inertia reel. (Seat Belt Inertia Reel Removal)
3. Use 1/2 and 3/8 wrenches to remove the bolt and nuts securing the outboard end of the belt assembly where it attaches to the outboard longeron. See Figure 60.
Figure 60. Co-pilot Side Shown
4. Use a 1/2 wrench to remove the bolt securing the inboard end of the seat belt where it attaches to the inboard keel structure; it is threaded into a nutplate. See Figure 61.
Figure 61. Co-pilot Side Shown
Installation
5. Install the seat belt buckle side of the belt assembly onto the inboard keel as shown in Figure 61. Torque the bolt to 90 in-lbf.
6. Install the free end of the seat belt assembly into the outboard longeron as shown in Figure 60. Torque the fastener to 85 in-lbf.
7. Install the seat belt inertia reel. (Seat Belt Inertia Reel Installation)
8. Verify proper function of the inertia reel.
9. Install the seat pan, seat back, seat back closeout, and baggage floors (Seat Pan Installation)(Install Seat Back)(Baggage Floor Installation).
Verification Method
Procedure is complete when steps are finished.