ICON A5 MM : Fuel System : Fuel Pump : Maintenance Instructions : Remove Fuel Pump
Remove Fuel Pump
100505-01
Use this procedure to remove the Fuel Pump.
Applicable Aircraft Serial Numbers
All
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
07—Fuel System
Safety Equipment
As Needed
Consumables
None
Task Instructions
1. Remove the Baggage Floor. (Baggage Floor Removal)
2. Remove the LHS Baggage Sidewall Panel. (Baggage Sidewall Panel Removal)
3. Remove LHS Seat Back. (Remove Seat Back)
4. Ensure the Fuel Shutoff Valve is closed.
5. Disconnect connector D9100P from Auxiliary Fuel Pump.
Figure 167. Fuel Pump Looking AFT, RHS
6. Disconnect connector D9087P from Main Fuel Pump.
7. Loosen the AN-6 Coupling Nut from the Fuel Feed Line at the top of the elbow located at the Fuel Pump Outlet. Use a rag to catch any fuel. Separate fuel line and elbow.
Note: 
If necessary, loosen the P-clamp to separate the fuel line.
8. Loosen the AN-6 Fitting to remove the elbow from the Fuel Pump Outlet. Cap and plug open lines throughout.
9. Loosen the AN-6 Fitting to remove the fuel line from Fuel Pump Inlet.
10. Remove the four nuts and washers securing the Fuel Pump to the Baggage Floor Support. Save hardware for re-installation.
11. Remove the Fuel Pump from the aircraft.
Verification Method
Install the new Fuel Pump. (Install Fuel Pump)